Free Beading Instructions: Black and Pearl Magnetic Wrap - Eureka! Beads Australia

Black and Pearl Magnetic Wrap
[EX05601]

Click to enlarge

Materials:	Tools:
1m tigertail	Crimping Pliers
50 plain metal balls	Wire Cutters
25 square cut magnets
2 small crimps
48 4mm bicone glass crystals
24 small freshwater pearls
2 decorative metal beads with large holes

Thread a small crimp, followed by a plain metal ball onto the tigertail. Thread the tail of the wire over the top of the plain metal ball and through the crimp. Pull up tightly, crimp down and cut off excess wire. Thread the decorative metal bead with the large hole on, so that it hides the crimp. Now thread on your pattern:

- a square cut magnetic bead
- a 4mm bicone glass crystal
- a plain metal ball
- a small round freshwater pearl
- a plain metal ball
- a 4mm bicone glass crystal

Repeat the pattern another 23 times, finishing with a square cut magnetic bead. To end the wrap, thread on a large decorative metal bead, followed by a small crimp (don't squish it down yet) and a plain metal ball. Thread the tail of the wire over the top of the plain metal ball and through the crimp. Pull up tightly (leaving a 4mm gap between the decorative metal bead and the crimp to allow for bending). Crimp down and cut off excess wire.

© 2010 www.eurekabeads.com.au. These free beading instructions may be used for personal use only.
Click on the buttons below to share these instructions with your friends

Download the full instructions as a PDF file.

This FREE beading project uses the followng products: