Free Beading Instructions: Black 2 Strand Bicone Bracelet - Eureka! Beads Australia

Black 2 Strand Bicone Bracelet
[EX05211]

Click to enlarge

Materials:	Tools:
38 6mm bicone glass crystals	Wire Cutters
36 plain metal beads	Crimping Pliers
1 magnetic clasp with loops
2 spiky decorative metal beads
2 small tube crimps
40cm tigertail
note: quantities in indicated make a 'standard' bracelet (our bracelet is 18cm). Our bracelet was made with gold coloured findings, a bronze clasp and black crystals.

Pick up the tigertail and thread through the loop on one end of the magnetic clasp. Continue threading until the magnetic clasp sits halfway along the strand. Fold the strand of tigertail in half, and thread a small tube crimp over the two strands and up to the magnetic clasp. Crimp down securely.

Thread a spiky decorative metal bead over the two strands, so that it sits up tight next to the magnetic clasp, hiding the crimp. Now, separate the two strands, and thread onto each strand:
-a 6mm bicone glass crystal
- a plain metal bead

Repeat this pattern on both strands, until you have 18 bicone glass crystals on each strand. Finish with one more bicone glass crystal on each strand.

Bring the two strands together again, and thread on a spiky decorative metal bead, followed by a small tube crimp. Thread on the other loop in the magnetic clasp, then take the tigertail back through the crimp. Pull up tightly, squish down the crimp and cut off any excess tigertail. Your bracelet is now ready to wear!

ï¿½ 2009 www.eurekabeads.com.au. These free beading instructions may be used for personal use only.

This FREE beading project uses the followng products: