Free Beading Instructions: Crystal Necklace - Eureka! Beads Australia

Red Crystal Necklace
[EX50411]

Click to enlarge

Materials:	Tools:
50cm tigertail	Crimping Pliers
6 4mm bicone glass crystals	Wire Cutters
1 parrot clasp
12 small crimps
4 jump rings
14 plain metal balls
1 head pin
note: quantities in [square brackets] indicate how many of that particular material we used. Depending on what size bracelet you're making, you might need more or less.

Thread one end of the tigertail through a small crimp, a small metal ball and the loop on the parrot clasp. Go around the parrot clasp and back through the metal ball and the crimp. Using the crimping pliers, squeeze the crimp shut to hold everything in place.

Thread on one small crimp and crimp into place 70mm from the parrot clasp. Thread on your first set of floating beads ie: one plain metal ball, one 4mm bicone glass crystal, one plain metal ball and one crimp. Crimp into place.

Leave another 70mm gap and thread on the next set of floating beads, repeating the same pattern as above.

Repeat the pattern until you have five sets of floating beads each spaced 70mm apart.

Put your necklace aside and pick up one of the jump rings. Open the jump ring up slightly and close completely. Now pick up your necklace again. On the end without the clasp, thread a crimp (don't squish it down yet), followed by a plain metal ball, 70 mm from your last set of floating beads. Next thread on your closed jump ring. Thread the tail of the wire over the top of the jump ring and through the metal ball and crimp. Pull up tightly, crimp down and cut off excess wire. Open up one of the left-over jump rings and thread it onto the jump ring already on the necklace. Repeat with the other two to create an extension chain.

Make the decorative tag end by threading one metal ball, one crystal and one metal ball on the head pin. Cut the head pin 5mm from the last metal ball. Bend the end of the pin to make a loop with your twirly wirlie pliers. Your floating crystal necklace is now ready to wear.

ï¿½ 2009 www.eurekabeads.com.au. These free beading instructions may be used for personal use only.

Download the full instructions as a PDF file.

This FREE beading project uses the followng products:

Parrot Clasps	Head Pins - 50mm	Tigertail - 10m roll
3mm Plain Metal Beads	Small Tube Crimps	4mm Bicones - Red