Black and Pearl Magnetic Wrap: Project Instructions

[EX05601]

Difficulty

Is it a bracelet? A necklace? It's both! With no clasp, this wrap uses magnets to stay shut. Wrap it small and tight to wear as a bracelet, or long and loose to wear as a necklace. Follow our instructions to learn how.

MATERIALS REQUIRED

TOOLS REQUIRED

1m tigertailCrimping Pliers
50 x 3mm plain metal ballsWire Cutters
25 square cut magnets
2 small crimps
48 x 4mm bicone glass crystals
24 small freshwater pearls
2 decorative metal beads with large holes
   

Thread a small crimp, followed by a plain metal ball onto the tigertail. Thread the tail of the wire over the top of the plain metal ball and through the crimp. Pull up tightly, crimp down and cut off excess wire. Thread the decorative metal bead with the large hole on, so that it hides the crimp. Now thread on your pattern:

- a square cut magnetic bead
- a 4mm bicone glass crystal
- a plain metal ball
- a small round freshwater pearl
- a plain metal ball
- a 4mm bicone glass crystal

Repeat the pattern another 23 times, finishing with a square cut magnetic bead. To end the wrap, thread on a large decorative metal bead, followed by a small crimp (don't squish it down yet) and a plain metal ball. Thread the tail of the wire over the top of the plain metal ball and through the crimp. Pull up tightly (leaving a 4mm gap between the decorative metal bead and the crimp to allow for bending). Crimp down and cut off excess wire.

© 2017 www.eurekabeads.com.au These free beading instructions may be used for personal use only

PRINT PAGE