Free Beading Instructions: Pinky Red Mesh Earrings - Eureka! Beads Australia

Pinky Red Mesh Earrings
[EX50031]

Click to enlarge

Materials:	Tools:
2 ear wires	2 Crimping Pliers
2 jump rings
26 8mm round faceted glass crystals
superglue
4 crimp leather ends
2 x 14cm wire mesh tubing
note: our earrings were made with clear AB crystals, silver coloured findings and red wire mesh tubing

Take one of the length of wire mesh tubing, and fill with 13 8mm round faceted glass crystals. Bring the two ends together and place in a leather crimp. Add a dab of glue and squish down both sides.

Open up another leather crimp, add a dab of glue and place over the first leather crimp - but this time cover the other side (ie you should not be able to see the "join" of the original leather crimp). Squish down both sides. Open up one of the jump rings and thread through the two loops on top of the leather crimps and the bottom loop in the earwire. Close securely.

Repeat to make the second earring. Your earrings are now ready to wear!

© 2010 www.eurekabeads.com.au. These free beading instructions may be used for personal use only.
Click on the buttons below to share these instructions with your friends

This FREE beading project uses the followng products:

DISCONTINUED Clear AB 8mm Round Faceted Glass Crystal Strands	6mm Strong Jump Rings	Standard Ear Wires
Crimp Leather Ends	Wire Mesh Tubing - 1 metre	Blue/Grey Crimping Pliers (Needle Nose)