Free Beading Instructions: Simple Crystal Red Wire Mesh Tubing Necklace - Eureka! Beads Australia

Simple Crystal Red Wire Mesh Tubing Necklace
[EX50441]

Click to enlarge

Materials:	Tools:
2 crimp leather ends	Crimping Pliers
1 parrot clasp	Wire Cutters
medium twisted loop chain [5cm]
4 jump rings
wire mesh tubing [550mm]
superglue
4mm bicone & 8mm round faceted glass crystals [~600]
note: quantities in [square brackets] indicate how many of that particular material we used. Depending on what size necklace you're making (our necklace is 600mm), you might need more or less.

Take the wire mesh tubing and place the end in a leather crimp. Add a tiny dab of glue and squish both sides of the leather crimp down, to hold the wire mesh tubing in place. From the other end, fill the hollow mesh tubing with a mix of 4mm glass bicone & 8mm round faceted glass crystal beads (we used clear AB, red and clear, with black tubing). Once the tubing is full to the length you want, cut off any excess tubing, close the tubing by placing the end in a leather crimp, adding a dab of glue and squishing down both sides.

On one side of your necklace, add a jump ring and a parrot clasp to the leather crimp. On the other side, add a couple of jump rings.

ï¿½ 2009 www.eurekabeads.com.au. These free beading instructions may be used for personal use only.

This FREE beading project uses the followng products: