Free Beading Instructions: Teal Mesh Tubing & Pendant Necklace - Eureka! Beads Australia

Teal Mesh Tubing & Pendant Necklace
[EX20411]

Click to enlarge

Materials:	Tools:
50cm wire mesh tubing	Crimping Pliers
1 parrot clasp	Wire Cutters
4 jump rings
1 rectangular glass pendant
2 crimp leather ends
~500 6mm bicone glass crystals
superglue
note: these quantities make a 45cm length necklace. To make a longer necklace, simply add more wire mesh tubing. Our necklace was made with black wire mesh tubing, green 6mm crystals a blue large green/gold splotches rectangular glass pendant and silver findings

Take the 50cm piece of wire mesh tubing and fold in half. Thread the folded end through the rectangular glass pendant, until there is about 5cm of the tubing poking out. Take the two loose ends and thread them through the folded loop on the other side of the pendant. Pull up tightly.

Take one end of the wire mesh tubing and fill it with 6mm bicone glass cyrstal beads (we used medium green crystals). Then, take that end of the wire mesh tubing and place it in a leather crimp. Add a tiny dab of glue and squish both sides of the leather crimp down, to hold the wire mesh tubing in place. Repeat this process with the other end of the wire mesh tubing. On one side of your necklace, add a jump ring and a parrot clasp to the leather crimp. On the other side, add a couple of jump rings.

Picture of the end of a purple necklace, with leather crimps

ï¿½ 2009 www.eurekabeads.com.au. These free beading instructions may be used for personal use only.

This FREE beading project uses the followng products: